Excellent Condition Walrus Audio CANVAS STEREO DI / LI

【WAL-CANV/S】

This is a beautiful, like-new item purchased from Sound House in February 2026.

I only used it at home to compare its sound quality with other DIs I own.

Thank you for your consideration.


Quoted from the sales page below:

The Canvas Stereo is a passive Line Isolator (LI) and Direct Injection (DI) device that converts unbalanced signals to balanced signals for transmission to the FOH recording interface or mixer. If you use an Amp in a box like the ACS1 to output acoustic or bass guitars directly to a mixer or interface, the Canvas Stereo will be your new secret .

Direct Injection Mode
Use DI mode when connecting high-impedance sources (1,000Ω or higher, such as electric guitars and basses) with unbalanced signals. The signal is attenuated by -20dB (-35dB with PAD engaged) and converted to a balanced signal via a transformer connected to the XLR output. The signal is then boosted to line level using the gain on your mixer or preamp.

Line Isolator Mode
Use LI mode when connecting low-impedance (1,000Ω or less) sources (such as amp + cabinet simulators like the ACS1, synthesizers, etc.) with unbalanced signals. The signal is converted to a balanced signal via a transformer connected to the XLR output at full volume. Less preamp gain is required.

FEATURES
・Flat frequency response (20Hz-20kHz).
・SUM switch: When OFF (not pressed), the L and R inputs are connected to their respective thru channels. When ON (pressed), the thru jacks are combined, allowing output through either thru jack.
・PAD switch: Enables a -15dB input pad (DI mode only) to reduce the hot signal and minimize distortion.
・D.I./L.I switch: Selects between DI (Direct Injection) and LI (Line Isolator) modes.
・GND Lift: Isolates the GND pin of the XLR to eliminate hum noise if it occurs.